Sears C935-355180, Руководство пользователя

Страница: 4 / 28

UNPACKING AND ASSEMBLY
Before assembling your MOWER, check that you have received the
following in the shipping carton.
See Figure 1.
A. Mower
B. Upper Handle
C. Lower Handle
D. Discharge Chute
E. Plastic Bag with fastening knobs and cable ties
ASSEMBLING THE HANDLE (FIGURE 2A)
1. Your mower carton contains the mower, 2 handles, discharge chute and
1 plastic parts bag.
2. Fasten the upper and lower handle halves together using the eye bolts
(already installed on the power and flip cords) and the fastening knobs
from the plastic bag.
Make sure the power cord and switch are on
the same side of the mower as the discharge area and that the flip
locking mechanism is on the opposite side . There are three holes on
the upper handle, this allows the handle height to be set in three
positions. Choose the hole that best suits your overall height. Install the
eye bolts to the outside of the handles so that the knobs are on the
inside. Tighten the knobs securely.
ATTACHING THE HANDLE (FIGURE 2B)
1. UNPLUG TOOL, AND WAIT FOR BLADE TO COME TO A
COMPLETE STOP.
2. Brace the front end of the mower so that it cannot roll forward.
3. Align the ends of the lower handle vertically over the flip bracket
installation slots with the power cord on the same side as the
discharge area. (Figure 2B)
4. Spread the handle sightly and push the handle down until they engage
on the flip brackets, taking care not to pinch or damage the power or flip
cord.
5. Pull up on the handles to ensure a secure fit.
6. Install cable ties, from plastic bag, in locations shown on lower handle.
2
ASSEMBLY
FIGURE 1
FIGURE 3
FIGURE 2A
D
C
A
B
E
FIGURE 2B
REMOVING THE HANDLE (FIGURE 3)
1. UNPLUG TOOL, AND WAIT FOR BLADE TO COME TO A COMPLETE
STOP.
2. Brace the front of the mower so that it cannot roll backward.
3. Pull the handle release lever and rotate the handle to a vertical position.
4. Grasp the ends of the lower handle with both hands. Pull the two sides of
the handle apart while pulling up on the handle. Be careful not to damage
cords when removing handle.
CAUTION:
NEVER use a sharp object to move jacketed wires
out out of the way.
!
MULCHING
The mower is designed to mulch or discharge the grass depending on whether
the mulch door is closed (mulching) or the mulch door is up and the discharge
chute is in place (discharging). No further assembly steps are required if you
are mulching. PROCEED TO OPERATION SECTION PAGE 4.
DISCHARGE CHUTE INSTALLATION
(If you wish to discharge the clippings rather than mulch,
perform these steps)
1. UNPLUG TOOL, AND WAIT FOR BLADE TO COME TO A COMPLETE
STOP.
2. Open mulch door by pulling on the mulch door finger grip. (Figure 4A)
3. Align the discharge chute arrows with the positioning arrows on the
lawnmower deck and insert the discharge chute as shown.
4. Position the chute until the chute hooks are trapped under the deck hooks
and release the chute and door. (Figure 4B)
A
B
FIGURE 4