Seamax Inflatable Boat – English User Manual
- 26 -
IMPORTANT NOTE OF BOAT INFLATION
:
Best not inflate or deflate one air chamber at a time. When inflating or deflating, maintain a balanced air pressure
between air chambers to prevent stress or potential damage to the inside diaphragms that separate the air
chambers.
Do not use any type of air compressor to inflate the boat.
Install the removable seat before the boat is fully inflated. Hook the flanges that are located on the bottom of the
seat into the nylon straps on the side air chambers.
Do not inflate the keel until floorboards are installed.
Start by inflating both side chambers. Then inflate the nose. After you have inflated these 3 or 5 compartments
you can start inflating the keel.
Remember that air temperature and direct sunlight can have an effect on the air pressure for up to 2 PSI when in
a cold morning and hot afternoon.
OARS SETUP
1.
First Insert the oar piece in to the oar holder since new holder may be tight.
2.
Put the rear piece into the oar lock stick. Join two pieces together, click the oar click in.
3.
If it is not fitting well, switch over to other piece to try again.
4.
Screw up the oar lock cap, finished & ready for use.
OAR SPEC - Two pieces oar, Blade piece & Handle piece; 5.3FT & 5.8FT Assembled Length; Oar handle diameter:
1 ¼ inch; Oar lock hole diameter: 3/8 inch.
