instructions for
DIGITAL DIESEL & FLUID FLOW METER
model no:
Tp101.v2
Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions,
and properly maintained, give you years of trouble free performance.
IMPORTANT:
PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
1. SAFETY
WARNING!
ensure health & safety, local authority, and general workshop practice regulations are strictly adhered to when using this
equipment.
9
familiarise yourself with product application and limitations, as well as the specific potential hazards peculiar to this product.
9
maintain the meter in good condition (use an authorised service agent).
9
replace or repair damaged parts. use genuine parts only. non authorised parts will invalidate the warranty.
9
use only to meter diesel fuel, kerosene, petrol, water, windscreen washer or water/urea solutions.
9
ensure safety eye protection and protective clothing are worn when using this product.
9
Keep the work area clean, uncluttered and ensure there is adequate lighting.
9
maintain correct balance and footing. ensure the floor is not slippery and wear non slip shoes.
9
Keep children and unauthorised persons away from the working area.
9
After use, drain any fluids from the equipment before storage.
9
dispose of waste liquids in accordance with local authority regulations.
8
DO NOT
exceed the maximum pressure of 50bar.
8
DO NOT
use the equipment near open flames.
8
DO NOT
smoke whilst using this equipment.
8
DO NOT
use for corrosive fluids.
8
DO NOT
dismantle, tamper with or adapt the equipment for any purpose other than for which it is designed.
8
DO NOT
use the unit if it has been dropped or mishandled, check the unit to ensure there is no damage.
8
DO NOT
use taper connections, use parallel connectors only.
8
DO NOT
use compressed air on the turbine, the excessive rotation will damage the unit.
9
Keep the meter clean and store in a safe dry, childproof location.
WARNING! DO NOT
allow uncontrolled discharge of fluids thus polluting the environment. All liquids must be disposed of according to
local authority regulations.
2. INTRODUCTION
robust rubber housing with integral digital electronic metering. easy to read large, four digit, 28mm high lcd display calibrated in litres, quarts,
pints and gallons. features flow rate indication. 1” x 1” BsP male/female fitting. Powered by 2 x AAA batteries (supplied). iP65 rated protection.
3. SpECIFICATION
model no: ...................................................................tP101.V2
flow rate: ................................................................7-120ltr/min
4. OpERATION
WARNING!
DO NOT
use the meter without a filter installed BEFORE the meter.
4.1.
Installation refer to fig's 1 & 3
4.1.1.
This is a bi-directional meter with 1” threaded male & female ports. The meter can be fixed in any position - fixed inline or
mobile on a control nozzle.
4.1.2.
remove the four screws (2) and separate the card housing (5) from the turbine assembly (6).
4.1.3.
Rotate the card housing in any of the four positions as shown in fig.1 and tighten the card housing with four screws (2)
refer to
instruction
manual
fig.1
tP101.V2 | issue:1 30/11/17
Original Language Version
© Jack sealey limited
