WARNING: THIS MACHINE IS HEAVY!
Exercise care when lifting and moving. Be aware of good manual handling practice.
DO NOT
lift by the band saw arm.
When removed from the crate, remove protective grease with paraffin or similar.
4.1.
Motor Fitting.(fig.1)
WARNING:
fitting the motor requires at least 2 persons.
4.1.1. remove the nut and washer from the motor support spindle and withdraw the spindle.
4.1.2. offer the motor up to the support bracket, with the lugs on the motor to the right of those on the bracket.
4.1.3. slide the spindle in with the thread first. When through the bracket and motor lugs, place the washer and thread the nut onto the
spindle and tighten.
4.1.4. Line the driving and driven pulleys up by edging the motor along the spindle until aligned.
4.1.5. Place the V-belt over the pulleys.
4.1.6. using a second person to support the motor, remove the tension strut bolt and washer from the motor mounting plate (fig.2).
4.1.7. Place the washer on the tension strut bolt and place the bolt through the slot in the tension strut. Insert the bolt into the threaded hole
in the motor base.
Lift the motor to tension the V-belt.
4.1.8. tighten the tension strut bolt to secure the motor (fig.2).
4.2.
Belt Guard Fitting.
4.2.1. remove the two securing bolts and washers from the casting behind the pulleys.
4.2.2. remove the bridge piece (fig.3) from the belt guard by unscrewing the self-tapping screws.
4.2.3. slide the belt guard around the spindles of the motor and gearbox.
4.2.4. secure the belt guard to the casting using the securing bolts and washers (fig.4).
4.2.5. refit the bridge piece using the self-tappers.
4.2.6. close and lock the belt guard by means of the securing screw.
4.3.
Motor Wiring.
4.3.1. Locate the flexible conduit holding the motor input wiring.
4.3.2. remove the connection box lid, gasket and the plastic terminal cover.
4.3.3. connect the flexible conduit to the connection box using the cable gland found on the end of the conduit.(fig.6).
4.3.3. connect the earth terminal to the earth point in tandem with the earth lead from the motor (fig.5).
4.3.4. connect the live (brown) and neutral (blue) leads to either of the motor terminals. the motor will run in a clockwise direction
irrespective of the input connections (fig.6)
4.3.5. replace the plastic terminal cover, gasket and connection box cover.
fig.1
fig.2
fig.3
fig.4
fig.5
4.
ASSEMBLY
fig.6
Original Language Version
sm353cE.V2 Issue: 5 (L) - 30/05/17
© Jack sealey Limited
