Always provide adequate support for long and heavy material.
DO NOT
turn bandsaw on until the workpiece is secured in the vice and the blade has been positioned just above the workpiece.
DO NOT
over tighten the blade as it will stretch and warp.
DO NOT
allow children or untrained persons to operate the machine. Keep them away from the work area.
check the alignment of moving parts regularly; for safest performance keep the machine clean at all times.
turn off the machine before raising the blade
Avoid unintentional starting.
remove, clean and inspect the blade brush regularly.
remove any adjusting keys and wrenches from the bandsaw before turning it on.
replace or repair damaged parts. use recommended parts only; unauthorised parts may be dangerous and will invalidate the
warranty.
Keep hands and body clear of the work table when operating the bandsaw.
remove ill fitting clothing, ties and loose jewellery; tie back long hair.
Ensure there are no flammable materials near the work area.
When not in use isolate from the electric supply, slacken blade tension (see section 6.3). Ensure that the machine cannot be accessed
by children.
2.
INTRODUCTION
3.
SPECIFICATION
motor Pulley
saw Pulley
B
c
D
f
G
H
Recommended blade teeth per inch (tpi) for nominal cut length
cut length
<13mm
6-16mm
8-22mm 17-40mm >38mm
tpi
24 18 14 8 4
Cutting Chart for Flat and Round Bar
Recommended Pulley Selection for Various Metals
Material
Motor Pulley
Saw Pulley
Blade Speed
Tool, stainless or alloy steel.
Bearing bronze.
Small (A)
Large (E)
25m/min
Medium to high carbon steel.
Hard brass or bronze. Cast iron. Medium (B)
Large (F)
40m/min
Low to medium carbon steel.
Soft brass.
Medium (C)
Medium (G)
51m/min
Aluminium. Copper. Brass.
Large (D)
Small (H)
71m/min
E
A
capacity 90° round .............................................................Ø230mm
capacity 90° square/rectangular H x W ......................230 x 370mm
capacity 45° round .............................................................Ø185mm
capacity 45° square/rectangular H x W ......................230 x 185mm
Blade size .....................................................25.0 x 0.89 x 3035mm
Blade speeds ................................................. 25, 40, 51, 71mtr/min
motor Power ...........................................................................1120W
Power supply .................................................................... 230V/1ph
Weight .....................................................................................285kg
Saw arm is fitted with hydraulic damping to prevent the arm being dropped onto the workpiece and to ensure smooth cutting performance.
Coolant fluid system. Heavy-duty single phase electric motor with over-current sensor to cut power in the event of blade jam.
Original Language Version
sm353cE.V2 Issue: 5 (L) - 30/05/17
© Jack sealey Limited
