9
Feed the workpiece against the direction of rotation of the belt. Feeding from the other direction will cause the workpiece to be thrown
out at high speed.
8
DO NOT
force the workpiece on the machine.
8
DO NOT
over reach, loss of balance could result in falling onto the moving machine.
8
DO NOT
stand on the machine.
8
DO NOT
leave the machine until it has come to a complete stop or leave the machine running unattended.
9
Make the machine secure against accidental start up by untrained persons, children etc. by using locks.
9
Always use in well ventilated areas and provide for proper dust removal using a dust collection system.
1.3.
OPERATIONAL SAFETY
8
DO NOT
use machine until it is assembled and installed according to instructions.
9
Obtain training from a qualified person before using.
9
Use with correctly installed/operating guards in place.
9
Check belt for wear and tension and correct installation. If the belt is damaged or if it can not be tensioned properly, replace it.
9
Ensure belt is tracking properly.
9
Keep arms, hands and fingers away from abrasive surfaces.
9
Avoid awkward stance, operation and hand positions which could cause contact with the sanding surface.
8
DO NOT
wear gloves or hold the workpiece with a rag.
8
DO NOT
start the machine with the workpiece against the sanding surface.
8
DO NOT
start the machine until all objects (tools, scrap pieces etc.) have been removed from the machine.
9
Maintain the minimum distance between the sanding surface and the workpiece rests and backstop.
8
DO NOT
sand workpieces shorter than 18cm (7”) and thinner than 0.8mm (1/32”).
9
Properly support long or wide workpieces.
9
Disconnect machine from mains supply and clean table/work area before leaving the machine. Lock the switch in the off position to
prevent unauthorised use.
9
Functional tests must be carried out before using the machine, including condition of belt, running speed and stop buttons.
2. INTRODUCTION
Suitable for metal and fabrication workshops. Robust construction designed for everyday use. Supplied with high quality abrasive belt. Graphite
plate on the platen to reduce belt friction. Powerful 1500W 230V motor with IP54 protection. No-volt release switch fitted to aid safe operation.
Bench or floor mounting (stand supplied).
3. SPECIFICATION
MODEL NO .......................................................... SM100.V2
Belt size
..........................................................
100 x 1220mm
B
elt speed ....................................................................
19m/s
Flat grinding surface .........................................
100 x 280mm
Motor power ....................................................
1500W - 230V
No load speed ..........................................................
2840rpm
CONSUMABLES:
BELTS:
S
B0012
...........................................
SM100 x 1220mm 80Grit
S
B0013
.........................................
SM100 x 1200mm 100Grit
4. FEATURES
1 Sanding belt cover
2 Pedestal bolts
3 Tool rest
4 Dust deflector
5 Sanding belt
6 Dust receiver/extraction port
7 Electric motor ventilation
8 Pedestal
8 A Base
9 Belt tracking adjustment knob
10 Emergency switch
11 Guard
12 Cover fixing bolt
13 Dust extraction port
14 Cover handles
fig.1
Original Language Version
© Jack Sealey Limited
S
M100.V2 Issue:2 22/07/2020
