Sealey Group, Kempson Way, Suffolk Business Park, Bury St Edmunds, Suffolk. IP32 7AR
01284 757500
01284 703534
www.sealey.co.uk
ENVIRONMENT PROTECTION
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted, taken to
a recycling centre and disposed of in a manner which is compatible with the environment. When the product becomes completely
unserviceable and requires disposal, drain any fluids (if applicable) into approved containers and dispose of the product and fluids
according to local regulations.
Note
: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior
notice. Please note that other versions of this product are available. If you require documentation for alternative versions, please email or call
our technical team on [email protected] or 01284 757505.
Important
: No Liability is accepted for incorrect use of this product.
Warranty
: Guarantee is 12 months from purchase date, proof of which is required for any claim.
WEEE REGULATIONS
Dispose of this product at the end of its working life in compliance with the EU Directive on Waste Electrical and Electronic Equipment
(WEEE). When the product is no longer required, it must be disposed of in an environmentally protective way. Contact your local solid
waste authority for recycling information.
8. MAINTENANCE
WARNING!
Ensure machine is switched off and disconnected from the mains supply, before carrying out any maintenance.
8.1.
CHANGING THE BELT
Refer to fig.7
8.1.1.
Remove dust receiver, fig.1.6.
8.1.2.
Loosen cover fixing bolt, fig.1.12, and hinge open cover.
8.1.3.
Pull lever fully forward to loosen belt tension, fig.2.
8.1.4.
Slide off used belt and slide on new belt, observing the direction of travel.
8.1.5.
Align the belt so that it is perpendicular with the drive wheel and the driven wheel, see fig.8.
8.1.6.
Push the lever back to re-tighten the belt.
8.1.7.
Close the cover and secure the cover fixing bolt, fig.1.12.
8.1.8.
Refit the dust receiver, fig.1.6.
8.2.
Check tightness of all fixings before use, including work rests.
8.3.
CLEANING
8.3.1.
Keep machine and work area clean at all times, especially the motor air inlets.
9. TROUBLESHOOTING
PROBLEM
CAUSE
SOLUTION
Motor will not run
1. Defective On/Off switch
2. Motor unserviceable
1. Replace switch
2. Replace motor - professional repair only
Machine slows down when sanding
1. Drive belt too tight
2. Applying too much pressure to workpiece, onto belt
1. Decrease belt tension
2. Ease up on pressure
S
anding belt runs off the pulleys
1. Belt not tracking properly
1. Adjust belt tracking. See section 7.1.
fig.7
fig.8
Original Language Version
© Jack Sealey Limited
S
M100.V2 Issue:2 22/07/2020
