• 8 •
2.
Slide the ON/OFF switch to the ON position. Charging should begin
automatically. The display will show which port is in use.
3.
Charging time will vary, based on the mobile device’s battery size and
the charging port used.
NOTE:
Most devices will charge with any of the USB ports, but may
charge at a slower rate.
NOTE:
The 3A
USB port requires a specific charging cable
(not included).
4.
When finished using the USB port, disconnect the charging cable
from your mobile device and then disconnect the charging cable from
the unit. Slide the ON/OFF switch to the OFF position.
5.
Recharge the unit as soon as possible after each use.
NOTE:
If no USB device is connected, power to the USB ports will
automatically shut off after 30 seconds.
7.3 USING THE LED LIGHT
1.
Slide the ON/OFF switch to the ON position.
2.
Hold down the display button for 3 seconds.
3.
Once the LED light is on, press and release the display
button to
cycle through the following modes:
•
Steady glow
•
Flash for an SOS signal
•
Flash in strobe mode
4.
When finished using the LED light, press and hold the display
button until the light turns off.
5.
Slide the ON/OFF switch to the OFF position.
6.
Recharge the unit as soon as possible after each use.
8. MAINTENANCE INSTRUCTIONS
1.
After use and before performing maintenance, unplug and disconnect
the unit.
2.
Use a dry cloth to wipe all battery corrosion and other dirt or oil from
the battery clamps, cords, and the outer case.
3.
DO NOT
open the unit, as there are no user-serviceable parts.
9. STORAGE INSTRUCTIONS
1.
Charge battery to full capacity before storage.
2.
Store this unit at temperatures between -4°F-
+
140°F (-20°C-
+
60°C).
3.
Never completely discharge the battery.
4.
Charge after each use.
5.
Charge at least once every month, if not in frequent use, to prevent
over-discharge.
