Fig.2
Fig.3
LOCKING
BUTTON
WARNING! Ensure you read, understand and apply the safety instructions in Section 1.
Ensure the power control switch is NOT locked on before plugging into the mains.
5.1.
Hold the polisher firmly with one hand on the handle grip and the other on the side handle. To
select the required speed rotate the speed selector switch (fig.4.2) to the required speed 1 to 6.
5.1.1. To start the polisher press and hold down the safety lock button (fig.4.1) and squeeze the trigger.
When releasing the trigger, the safety lock button will engage, preventing the polisher from being
inadvertently started.
WARNING! The high speed settings are intended for sanding. If used for polishing an excessive
amount of surface material may be removed.
Note:
As the rubber support disc is flexible, when sanding it should not be used head on, but at an
angle of approximately 10 to 20 degrees.
Contact your Sealey Dealer for details of compound heads and lambs wool bonnets.
6. MAINTENANCE
WARNING! Before attempting any maintenance ensure the unit is unplugged from
the mains power supply.
6.1.
Keep the machine clean and dry. Do not use abrasives to clean the unit. Ensure all
external head screws are tight.
6.2.
Clean regularly by blowing a jet of compressed air through side vents to ensure motor
ventilation is kept clear.
WARNING!
Wear approved safety eye protection and, if necessary, respiratory
protection.
NOTE: The following maintenance must only be carried out by a technically qualified
person or an authorised Sealey service agent.
6.3.
Check carbon brushes by removing each side screw (fig.5). Check to see if the brushes
are worn or cracked. If so, the brushes must be replaced to avoid sparking and damage
to the armature. Always change brushes as a pair. Use only genuine spare parts as
these are specifically designed for the machine. Failure to do so may be dangerous and
will invalidate your warranty.
6.4.
After each 500 hours of use replace the gear head grease to prevent gear wear and
possible drive failure.
5. OpERATION
Fig.4
1
2
Fig.5
WARNING!
The warnings, cautions and instructions discussed in this manual cannot cover all possible conditions and situations
that may occur. It must be understood that common sense and caution are factors which cannot be built into this product, but must
be applied by the operator.
noTE:
It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
IMpORTANT:
No liability is accepted for incorrect use of this product.
WARRANTY:
Guarantee is 12 months from purchase date, proof of which will be required for any claim.
INFORMATION:
For a copy of our latest catalogue and promotions call us on 01284 757525 and leave your full name and address, including postcode.
01284 757500
01284 703534
Sole UK Distributor, Sealey Group,
Kempson Way, Suffolk Business Park
,
Bury St. Edmunds, Suffolk,
IP32 7AR
www.sealey.co.uk
Web
Original Language Version
MS850PS Issue: 2 - 19/02/10
