WARNING!
Disconnect sander from power supply before changing accessories, servicing or performing maintenance.
Replace or repair
any damaged parts. Use genuine parts only, unauthorised parts may be dangerous and will invalidate the warranty.
6.1.
After each 50 hours use (or as required), remove dust by blowing air through the side vents and around the pad bearing. Periodic cleaning
will prolong machine life.
6.2
.
Change pads when required. Ensure pad and disc RPM ratings are equal to the machine rating. If the disc becomes
unbalanced, it will cause the bearings to wear.
6.3.
When not in use store in a safe, dry, childproof location.
6.4.
Check brushes every 200 hours of use. To access the brushes refer to fig.2. Undo the screws in the side of the motor casing and slide
off the covers. Using a small screwdriver lift the brush spring to one side and slide the brush out of its holder. If the brush is worn to half
of its original length it should be renewed. Using thin nosed pliers pull the brush connector off its connector. Slide the new brush into its
holder. Slide the connector onto the connector. Position the spring so that it bears down onto the end of the brush. Remember to renew
brushes as a pair. Fit rear covers back into place and retain it with the screws.
6.5.
All other service and maintenance must be carried out by an authorised service agent.
6. MAINTENANCE
fig.2
Parts support is available for this product. To obtain a parts listing and/or diagram,
please log on to www.sealey.co.uk, email [email protected] or telephone 01284 757500.
Environmental Protection
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted,
taken to a recycling centre and disposed of in a manner which is compatible with the environment.
When the product becomes completely unserviceable and requires disposal, drain off any fluids (if applicable)
into approved containers and dispose of the product and the fluids according to local regulations.
WEEE Regulations
Dispose of this product at the end of its working life in compliance with the EU Directive on
Waste Electrical and Electronic Equipment (WEEE). When the product is no longer required, it must be disposed
of in an environmentally protective way. Contact your local solid waste authority for recycling information.
NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
IMPORTANT:
No liability is accepted for incorrect use of this product.
WARRANTY:
Guarantee is 12 months from purchase date, proof of which will be required for any claim.
01284 757500
01284 703534
Sole UK Distributor, Sealey Group,
Kempson Way, Suffolk Business Park
,
Bury St. Edmunds, Suffolk,
IP32 7AR
www.sealey.co.uk
© Jack Sealey Limited
Original Language Version
DAS149 | Issue: 2S - 23/12/14
