SealerSales Impresse FRM-1010, Инструкция по эксплуатации

Страница: 21 / 48

F R M - 1 0 1 0 I N S T R U C T I O N M A N U A L
17
Figure 24. (1) Ink Roller, (2) Ink Roller Heating Block, (3) Swing Pole, (4) Adjusting Strut, (5) Ink Wheel Adjusting Device
7. Make Adjustments Between Printing Wheel and Silicone Wheel. The typesets/characters
on the printwheel should only touch the silicone wheel during the printing process. The
characters should not touch the silicone wheel at any other time. If the band sealer is used to seal
relatively thicker materials, the screw (Figure 25, Item #4) should be loosened. Rotate the
eccentric sleeve ( Figure 25 , Item #3) to ensure the characters/typesets slightly tough the silicone
wheel's surface. Refasten the screw after making adjustments.
Figure 25. (1) Printing Wheel, (2) Silicone Wheel, (3) Eccentric Sleeve, (4) Screw
8. Setting Printing Temperature. We recommend setting the ink temperature on the higher end.
Allow 5-10 minutes for the ink heating block and ink roller to reach the correct temperature.
Note: If band sealer is not in use right away, do not leave ink roller in the unit while temperature is on. This may
result in the ink roller melting and producing messy print.
9. Adjusting Printing Position. The coding seat knob determines printing position on your
material. For example, if you want to print on the right side of your bag, turn the coding seat to