F R M - 1 0 1 0 I N S T R U C T I O N M A N U A L
12
a.
To set the temperature, press the SET button.
b.
Press the <AT (auto tuning) button to move from the ones, tens, and hundreds place.
Adjust the value using the up and down arrows.
c.
Press the SET button to save the temperature settings. Your desired temperature
settings should appear in green in the SV Value.
d.
Wait until the PV temperature matches the SV temperature which should take
approximately 5-10 minutes.
e.
Please note:
Temperature will be in
Celsius
, not Fahrenheit. Do not attempt to make
additional adjustments to the temperature controller besides the temperature. The
temperature controller CANNOT be displayed in Fahrenheit and is ALWAYS in Celsius.
Please do not set the temperature controller above 200ºC
. Please contact your local
distributor if you need assistance.
6.
Adjust the pressure knob on your band sealer depending on the thickness of your bag material.
7.
Place material on the guide
(Figure 36, Item #1)
and allow the band sealer to pull your material
through. Make sure your material is flat on the guide. While the material is moving through the
band sealer, do not push or pull the material as this will cause irregular sealing.
8.
If the sealing belt is running off the guide wheels, make adjustments to the screws that are found
on the driven wheel seat
Item #1 & 2)
Figure 11.
(1) Driven Wheel Seat (Adjusting Block), (2) Driven Wheel Seat (Adjusting Block), (3)/(4) Adjusting Screws, (5) Springs
9.
Emergency Stop – Press the emergency stop to turn off the machine. In order to restart the
machine, you must release the emergency stop by turning the knob 120˚ clockwise.
10.
To shut down, turn off the heater switch and allow the temperature of the machine to drop
before turning off the power and fan switches.
Following this shut down procedure will significantly
prolong the life of machine and sealing belts.
Содержание Impresse FRM-1010
