Operating
37
English
5.
Unwind the film from the lower unwind roll at the rear side of the machine and pull it up
till it reaches the upper material roll.
6.
Allign the lower roll with the upper one.
7.
Now web the lower material roll.
•
Feed a pressure sensitive film without release liner underneath the splitter bar (A),
•
Feed all other films over the splitter bar (B).
8.
Pull the film forward until the end reaches above the nip and stick it to the film from the
upper section.
If the film has a release liner:
•
Peel off the release liner,
•
Pull it over the wind-up shaft,
•
Stick it from above onto the cylinder on the wind-up shaft.
When encapsulating:
•
Set the top pull roller in the upper position and lock it on both sides.
9.
Lower the in-feed table.
10.
Push the films with a leader panel into the nip using slow mode.
Note:
Use a leader panel of the same material, thickness and width as the panels to process.
When encapsulating it is recommended to use the provided release board as a leader.
Processing boards:
11.
Set the pressure for optimum result when the leader board passes through.
12.
Butt up the next boards.
13.
End up again with the leader board.
Processing thin images:
11.
When the leader board is through the nip, set the nip to zero and the pressure to 80%.
12.
Flip up the image guide and the table rollers.
13.
Feed in the images using the infeed table rollers.
While feeding the images:
•
Check and adjust the tension on the unwind- and wind-up shafts.
•
Check and adjust the pressure setting.
•
Now speed can be set to normal.
Содержание 80Pro
Страница 2: ...2 User Manual 80Pro...
