SEAL 54 EL, Руководство пользователя

Страница: 10 / 144

8
3.6 Setting up the laminator
Your 54 EL should be setup at the place where it will be used. The area must be a flat level surface.
The machine must be installed next to a power outlet. The plug and the outlet must be easily
accessible. Please ensure that you plug your laminator into a grounded outlet. The laminator should
only be connected to a power supply outlet able to safely supply the voltage and amperage marked
on the ratings label.
Note:
Make sure that the machine, in its final
location, has adequate space. You will
need room to feed, receive and trim
images. See Figure 4.
L = Maximum board length,
S = Minimum space 60 cm.(24").
Figure 4: Working Space
11. Move the machine to the designated working space.
12. Install Image Guide on table as shown in figure 5.
13. Install Take-up Tube onto right side first compressing spring on the right side then inserting left
side onto drive (figure 5).
14. Plug the power cable into the grounded outlet with appropriate service.
Figure 5
Image
Guide
Take-up
Tube