YAK 54.
Instruction Manual.
4
Work the aileron up and down several
times to “work in” the hinges and check
for proper movement.
Note:
HINGING THE RUDDER.
Glue the rudder hinges in place using the
same techniques used to hinge the ailerons.
Aileron control horn:
See pictures below
.
AILERON CONTROL HORN
3x20mm.
TURNBUCKLE INSTALLATION.
The hole location of turnbuckles shown in pic-
ture below .
The mounting holes of turnbuckle was
pre-drilled at factory.
Installing the turnbuckle for tail strut of hori-
zontal fin as same as pictures below.
8) After both ailerons are securely hinged,
firmly grasp the wing panel and aileron to
make sure the hinges are securely glued and
cannot be pulled out. Do this by carefully
applying medium pressure, trying to separate
the aileron from the wing panel. Use caution
not to crush the wing structure.
7) Repeat this process with the other wing
panel, securely hinging the aileron in place.
Horizontal fin bottom.
Turnbuckle.
Tail fin bottom.
2 sets.
3x45mm.
Hinge.
HINGING THE ELEVATOR.
Glue the elevator hinges in place using the
same techniques used to hinge the ailerons.
