CASSUTT 3M RACER.
Instruction Manual
18
RUDDER AND ELEVATOR PUSHROD
HORN INSTALLATION.
2) Install the rudder and elevator control horn
using the same method as with the rudder
and aileron control horns.
3) Position the rudder and elevator control
horn on the both side of rudder and elevator.
4) When you are sure that everything is
aligned correctly, mix up a generous amount of
Flash 30 Minute Epoxy. Apply a thin layer to the
mounting slot and to bottom of the vertical sta-
bilizer mounting area. Apply epoxy to the bot-
tom and top edges of the filler block and to the
lower hinge also. Set the stabilizer in place
and realign. Double check all of your measure-
ments once more before the epoxy cures. Hold
the stabilizer in place with T-pins or masking
tape and remove any excess epoxy using a
paper towel and rubbing alcohol. Allow the ep-
oxy to fully cure before proceeding.
Required Parts
•
1000mm Cable(2)
•
2.6mmx80mm threaded rod(2)
•
M3 metal clevis with silicone tubing(8)
•
Lock nut(4)
•
Cable lock(8)
M3 lock nut.
M3 clevis.
100 mm.
80mm.
1
1) Locate the items for this section of the
manual.
90º
Vertical
Stabilizer.
Horizontal
Stabilizer.
3) Slide the vertical stabilizer back in
place. Using a triangle, check to ensure that
the vertical stabilizer is aligned 90º to the hori-
zontal stabilizer.
Elevator pushrod.
Rudder pushrod.
2pcs.
2pcs.