SEA FURY.
Instruction Manual.
14
Because the size of servos differ, you
may need to adjust the size of the precut
opening in the mount. The notch in the
sides of the mount allow the servo lead to
pass through.
Using a small weight (
Weighted fuel pick-up
works well
) and thread, feed the string through
the wing as indicated.
!
1) Install the rubber grommets and brass
collets onto the aileron servo. Test fit the servo
into the aileron servo mount.
We recommended to use long servos
arm for all servos without throttle servo.
Small weight.
Wing bottom.
Thread.
Electric wire.
Thread.
!
2) Secure the servos with the screws pro-
vided from your radio system.
Masking tape.
!
4) Carefully slide the two wing halves
together and firmly press them together,
allowing the excess epoxy to run out. There
should not be any gap in the wing halves. Use
rubbing alcohol and a paper tower to clean up
any excess epoxy.
!
5) Apply masking tape at the wing join to
hold the wing halves together securely.
Epoxy.
INSTALLING THE AILERON SERVOS.
Small weight.
Servos.
Thread.
