Seagull Models NIEUPORT 28 REPLICA, Инструкция по сборке

Страница: 21 / 45

21
3) Slide the vertical stabilizer back in
place. Using a triangle, check to ensure
that the vertical stabilizer is aligned 90º
to the horizontal stabilizer.
4) When you are sure that everything is
aligned correctly, mix up a generous amount
of Flash 30 Minute Epoxy. Apply a thin layer
to the mounting slot and to bottom of the ver-
tical stabilizer mounting area. Apply epoxy to
the bottom and top edges of the filler block
and to the lower hinge also. Set the stabilizer
in place and realign. Double check all of your
measurements once more before the epoxy
cures. Hold the stabilizer in place with T-pins
or masking tape and remove any excess epoxy
using a paper towel and rubbing alcohol. Al-
low the epoxy to fully cure before proceeding.
5
.
6 .
7
.
8 .
9 .
10
.
Epoxy.
1) Install the elevator control horn using
the same method as with the aileron
control horns.
2) Position the elevator control horn on
the both side of elevator.
ELEVATOR - RUDDER PUSHROD
HORN INSTALLATION.