Epoxy.
Wing brace.
Wing brace.
3 x 10mm.
1) Coat both sides of one half of the dihedral
brace with 30 minute epoxy. Next, pour some
epoxy into the dihedral box in one wing panel.
. Use enough epoxy to fill any gaps.
Landing gear wire.
WING ASSEMBLY.
NOTE: We highly recommend using 30
minute epoxy as it is stronger and provides
more working time, allowing the builder to
properly align the parts. Using fast cure epoxy
when joining the wing halves could result in the
glue drying before the wing halves are aligned
properly which may result in failure of the wing
centre section during flight.
INSTALLING THE GEAR FAIRING.
See pictures below :
2) Carefully slide the two wing halves together
and firmly press them together, allowing the
excess epoxy to run out. There should not be
any gap in the wing halves. Use rubbing
alcohol and a paper tower to clean up any
excess epoxy.
3)Apply masking tape at the wing join to
hold the wing halves together securely.
Gear faring.
Plastic trap.
C/A glue.
ET6.
Instruction Manual.
6
