ET6.
Instruction Manual.
12
INSTALLING ELECTRIC MOTOR.
1) Align the tail wheel wire so that the wire
is parallel with the bottom of the rudder. The
control clasp has a predrilled hole through the
top of it. Slide this hole onto the tail wheel wire
while sliding the clasp over the bottom of the
rudder.
3) While holding the clasp firmly in place,
use a pen and outline the clasp onto the rud-
der.
4) Remove the clasp, and using a modeling
knife, remove the covering from inside the lines
you drew. Use 220 grit sandpaper and care-
fully roughen the inside surface of the nylon
clasp.
5) Slide the clasp back into position and care-
fully glue it into place using Kwik Bond Thin C/
A. Hold the clasp in place until the glue com-
pletely cures. Secure by 1 machine
screw.
MOUNTING THE CONTROL CLASP.
2) Using a ruler and a pen place a mark onto
the bottom of the rudder. The back edge of
the clasp should line up with this mark.You may
find it necessary to bend the tail wheel wire
down slightly so it lines up with the clasp with-
out binding.
There are 2 mouting box for your option. It is
depended your motor size.
MOTOR BOX
Control clasp.
2mm x 12 mm.
Machine Screw
Epoxy glue.
Insert blind nut.
MOTOR BOX
4.5 ly.
Motor.
