Seagate ST34555N, Руководство по эксплуатации продукта

Страница: 46 / 82

36 Hawk 4XL Product Manual, Rev. A
(“X” means the function selection can be made with jumpers on that connector;
( “Y” means the signal is available to host through that connector.)
Notes for Table 4 [ ]:
[a] Use either J6 or J1-Aux, but not both.
[b] The host can drive a remotely located Drive Activity LED using signal.
[c] The drive reads the ID (asserted low) from J1-Auxiliary pins 1, 3, 5 and 7 for 250 ms after power-on or
drive reset. Jumper plugs can be used on J1-Auxiliary pins 1-2, 3-4, 5-6 and 7-8 to set drive ID if desired,
but usually a connector/cable is plugged to J1-Auxiliary to run these signals to the host for remote ID
selection.
Table 4: Drive configuration selections summary
Interface
type
Function
Connector
Applicable
figure
J1 J6 J1-AUX J2
N Drive ID X, Y none 8
N Drive Activity LED Y [b] none 8
N Option select none X 11
W Drive ID X, Y X, Y [c] 9, 10 [a]
W Drive Activity LED Y [b] Y [b] 9, 10 [a]
W Option select X 11