Seagate Medalist 3220, Руководство по эксплуатации продукта

Страница: 26 / 40

2.3 Drive mounting
You can mount the drive in any orientation using four screws in the
side-mounting holes or four screws in the bottom-mounting holes. See
Figure 3 for drive mounting dimensions.
Important mounting precautions:
•
Allow a minimum clearance of 0.030 inches (0.76 mm) around the
entire perimeter of the drive for cooling.
•
Use only 6 x32 UNC mounting screws.
•
Do not insert the mounting screws more than 0.25 inches (6.25 mm)
into the mounting holes.
•
Do not overtighten the mounting screws (maximum torque: 3 inch-lb).
•
Do not use a drive interface cable that is more than 18 inches long.
pin 1
4-pin power
connector
ATA interface
connector
Alternate capacity and master/slave
jumper settings
Use this jumper setting if your computer fails
to boot because it cannot address drives with
more than 4,092 cylinders.
3.
Consult your computer manual to determine
whether your computer supports cable select.
1.
2. Use this jumper setting only if the drive does
not work with a jumper on pins 7 and 8.
1 3 5
2 4 6
7
8
Limit capacity to 2.1 Gbytes
(4,092 cylinders)
3
Slave
Master or single drive
Master with non-ATA
compatible slave
2
Enable cable select
1
Figure 2. Alternate capacity jumper and master/slave jumpers
18 Medalist 6540, 5130 and 3220 Product Manual, Rev. A