Seagate Hawk 2 ST11900N, Руководство по эксплуатации продукта

Страница: 69 / 82

Product Manual - Hawk 2 Family SCSI-2 (Volume 1), Rev. B 61
_________________________________________________________________________________________
[1] Part of active terminator circuits. Permanently mounted LSI terminators enabled in the drive (ST12400N
only) when it is first or last in the daisy-chain. See jumper header Figure 10.1-1 for terminator enabling jumper
TE.
[2] ANSI SCSI compatible circuits
[3] Total interface cable length should not exceed that specified in paragraph 11.6.2.2.1.
[4] Source of drive terminator power is an active circuit which has an input source voltage selected by jumper
plug TP. See Figure 10.1-1. This applies to model ST12400N only.
[5] Interface signals levels and logical sense at the drive I/O connector are defined as follows:
Logic Level Driver Output Receiver Input
Negated (0) >2.5 V: <5.25 V >2.0 V: <5.25 V
Asserted (1) <0.4 V: >0.0 V <0.8 V: >0.0 V
The difference in the voltages between input and output signals is due to the losses in the cable.
Figure 11.6.4-1. Single ended transmitters and receivers
Transmitter
(or transceiver)
Line Driver
Flat
Cable
Pair
[3]
[2]
[4]
[1]
110
Ohm
[4]
[1]
110
Ohm
Receiver
Line Receiver
[2]
TP TP
[5]