Seagate Cheetah NS SAS ST3400755SS, Руководство по эксплуатации продукта

Страница: 30 / 80

24 Cheetah NS SAS Product Manual, Rev. B
[5] See paragraph 6.2.1, "Conducted noise immunity." Specified voltage tolerance includes ripple, noise, and
transient response.
[6] During idle, the drive heads are relocated every 60 seconds to a random location within the band from
three-quarters to maximum track.
General DC power requirement notes.
1. Minimum current loading for each supply voltage is not less than 1.7% of the maximum operating current
shown.
2. The +5V and +12V supplies should employ separate ground returns.
3. Where power is provided to multiple drives from a common supply, careful consideration for individual
drive power requirements should be noted. Where multiple units are powered on simultaneously, the peak
starting current must be available to each device.
4. Parameters, other than spindle start, are measured after a 10-minute warm up.
5. No terminator power.
6.2.1 Conducted noise immunity
Noise is specified as a periodic and random distribution of frequencies covering a band from DC to 10 MHz.
Maximum allowed noise values given below are peak-to-peak measurements and apply at the drive power
connector.
6.2.2 Power sequencing
The drive does not require power sequencing. The drive protects against inadvertent writing during power-up
and down.
6.2.3 Current profiles
The +12V and +5V current profiles are shown below in figure 19.
Note: All times and currents are typical. See Table 2 for maximum current requirements.
+5V = 250 mV pp from 0 to 100 kHz to 20 MHz
+12V = 800 mV pp from 100 Hz to 8 KHz
450 mV pp from 8 KHz to 20 KHz
250 mV pp from 20 KHz to 5 MHz