Seagate CHEETAH NS 10K.2 ST3450802SS, Руководство по эксплуатации продукта

Страница: 27 / 80

Cheetah NS 10K.2 SAS Product Manual, Rev. B 23
6.0 Physical/electrical specifications
This section provides information relating to the physical and electrical characteristics of the drive.
6.1 AC power requirements
None.
6.2 DC power requirements
The voltage and current requirements for a single drive are shown below. Values indicated apply at the drive
connector.
[1] Measured with average reading DC ammeter or equivalent sampling scope. Instant12V current
peaks will exceed these values. Power supply at nominal voltage. N (number of drives tested) = 6, 35
Degrees C ambient.
[2] For +12 V, a –10% tolerance is allowed during initial spindle start but must return to ±5% before reaching
10,000 RPM. The ±5% must be maintained after the drive signifies that its power-up sequence has been
completed and that the drive is able to accept selection by the host initiator.
[3] See +12V current profile in Figure 1.
[4] This condition occurs after OOB and Speed Negotiation completes but before the drive has received the
Notify Spinup primitive.
Table 12:
ST3600002SS
DC power requirements
Notes
ST3600002SS
1.5 Gbit mode
ST3600002SS
3 Gbit mode
(Amps) (Amps) (Amps) (Amps)
Voltage +5V +12V [2] +5V +12V [2]
Regulation [5] ±5% ±5% [2] ±5% ±5% [2]
Avg idle current DCX [1] [6] 0.35 0.37 0.38 0.36
Maximum starting current
(peak DC) DC 3
σ
[3] 0.48 1.96 0.60 1.96
(peak AC) AC 3
σ
[3] 0.82 3.80 1.02 3.80
Delayed motor start (max) DC 3
σ
[1] [4] 0.43 0.04 0.46 0.04
Peak operating current:
Typical DCX [1] 0.38 0.66 0.39 0.65
Maximum DC 3
σ
[1] 0.38 0.68 0.40 0.66
Maximum (peak) DC 3
σ
1.00 2.50 1.02 2.58