Seagate CHEETAH NS 10K.2 ST3450802SS, Руководство по эксплуатации продукта

Страница: 63 / 80

Cheetah NS 10K.2 SAS Product Manual, Rev. B 59
The Ready LED Out signal is designed to pull down the cathode of an LED. The anode is attached to the
3.3 volt supply through an appropriate current limiting resistor. The LED and the current limiting resis-
tor are external to the drive. See Table 23 for the output characteristics of the LED drive signals.
9.5.2 Differential signals
The drive SAS differential signals comply with the intra-enclosure (internal connector) requirements of the SAS
standard.
Table 24 defines the general interface characteristics.
9.5.2.1 Eye masks
9.5.2.1.1 Eye masks overview
The eye masks are graphical representations of the voltage and time limits on the signal at the compliance
point. The time values between X1 and (1 - X1) cover all but 10
-12
of the jitter population. The random content
of the total jitter population has a range of
±
7 standard deviations.
Table 23: LED drive signal
State Test condition Output voltage
LED off, high 0 V
≤
VOH
≤
3.6 V -100 µ A < I
OH
< 100 µ A
LED o n, l ow I
OL
= 15 mA 0
≤
V
OL
≤
0.225 V
Table 24: General interface characteristics
Characteristic Units 1.5 Gbps 3.0 Gbps
Bit rate (nominal) Mbaud 1,500 3,000
Unit interval (UI)(nominal) ps 666.6 333.3
Impedance (nominal, differential ) ohm 100 100
Transmitter transients, maximum V
±
1.2
±
1.2
Receiver transients, maximum V
±
1.2
±
1.2