Seac ACTION, Руководство пользователя

Страница: 42 / 48

42
REPLACING THE BATTERY
• WARNING!
Batteries should always be replaced by an authorized SEAC Center,
because this is a delicate operation with a high probability of subsequent
flooding of the Action if performed by inexpert personnel.
SEAC declines all responsibility for problems resulting from changing the
battery.
• WARNING!
When replacing the CR2450 battery, it's a good idea to also replace the
O-ring of the battery cap an original SEAC O-ring.
a) Unscrew and remove the four screws from the battery compartment.
b) Insert a small flathead screwdriver into the special opening located on the
bottom of the cap to lift the lid.
c) If needed, again using the small flathead screwdriver, prize up the battery
from its housing and remove it.
d) Insert the new battery, snapping it into its housing and making sure that
the “+” polarity sign is facing outward.
e) Remove the old O-ring from the housing in the metal cover and replace
it with the new one. Make sure that the O-Ring is not damaged, and once
inserted make sure it isn't twisted at any point.
f) Position the cover on the Action case, and press it evenly downward. Make
sure that in the area around the screws, the cover is flush with the case.
g) Keep the cover pressed down on the Action case while replacing the four
screws. Although the four screws are screwed through four metal inserts
fixed in the case, we recommend not tightening with excessive force to
reduce the risk of stripping. The recommended torque is 12 Ncm. The
O-ring seal on the battery compartment is radial, so excessive closing force
on the compartment screws is not necessary.
NOTE
Do not dispose of used batteries in the environment or discard them as ordinary
waste; we recommend using special battery disposal services.