English
| P
age 2 | Quick Reference for SEABOB |
Read the comprehensive Operation Manual carefully before using the
SEABOB F5 S! Pay special attention to all safety information and the instructions
regarding the intended use!
Never expose the SEABOB and the charger to high temperatures (max. 60 °C / 140 °F) caused e.g.
by open fire, direct sunlight or by storage inside a closed motor vehicle or boot. If exposed to heat,
flammable gases can be discharged causing serious injury. In addition, the TFT display may become irreparably
damaged if exposed to heat.
Never transport a fully charged SEABOB by aircraft or over long distances. The SEABOB should only be
partially charged during transport (charge state "air transport / storage"). Do not switch off the SEABOB
for transport before the aircraft symbol is displayed. If instructions are disregarded, flammable gases can be
discharged causing serious injury.
Charge the SEABOB after each use (within 24 hours) and during longer periods of storage continuously
(trickle-charge) to at least the charge state "air transport / storage" to avoid irreparable total discharge
of the valuable High-Energy Li-Ion accumulator cells. Use only chargers supplied by CAYAGO AG and for each
respective specific SEABOB model.
SEABOB
Charge display appears after a brief system
check (Charge mode)
Charge symbol for partial charging appears,
SEABOB is being partially charged
Charge symbol for full charging appears,
SEABOB is being fully charged
Charging process is complete, SEABOB is
switched off after 5 seconds for air transport /
storage (Off mode)
Charging process is complete, SEABOB is
switched off after 5 seconds (Sleep mode)
User
1. Connect charger: First plug connector into con-
nection port, then plug mains plug into mains
socket
2. For partial charging (for air transport / storage)
tap green button
3. For full charging (for operation) tap red button
4. To complete partial charging: Disconnect the
charger when the aircraft symbol is displayed
5. To complete full charging: Disconnect the
charger when the completely full accumulator
symbol is shown
To complete the charging process, first pull the mains plug from the mains socket. Only then should you
disconnect the connector from the connection port. Danger of short circuit!
Note:
The SEABOB can only be switched on from Off mode or switched off into Off mode using a connected
and active charger.
Switching on (from Sleep mode)
Charging / Switching on / Switching off (Off mode)
➞
➞
➞
➞
➞
SEABOB
Display is switched off (Sleep mode)
Display is switched on, SEABOB logo and
prompt "push trigger" appear
SEABOB logo disappears again
Information display appears
User
1. Tap blue button
2. Push Trigger against Controlgrip
(within 5 seconds)
3. Release Trigger completely
➞
➞
➞
