SWING 2
31
M1
M2
OFF
ON
1
2
3
4
5
Example
Release
Example
Lock
PHASE 1
Make all the electrical connections and take care to bridge all the unused N.C. contacts.
If you are installing a motor reducer equipped with mechanical / hydraulic anticrushing device, set the motor torque
(trimmer Rv1) at maximum value and make the motor torque adjustment using the appropriate by-pass valves or clutch
adjustment screws located on the operators.
If you are installing a motor reducer not equipped with mechanical / hydraulic power limitaiton device,set the motor
torque at maximum value ONLY during the selflearning phase. Immediately afterwards set a motor torque value which
can assure the anticrushing safety, in accordance with the law in forcei.
WARNING !
THIS PROCEDURE IS POTENTIALLY DANGEROUS AND MUST BE EXECUTED EXCLUSIVELY BY
SPECIALIZED STAFF UNDER SAFETY CONDITIONS.
PHASE 2
Disconnect the power supply (Fig. 1), release the gate (Fig. 2) and place the leaves at half-open position (Fig. 3). Re-
lock the motor (Fig. 4) and connect again the power supply (Fig. 5).
2
1
WORKING TIMES SELFLEARNING
ON SWING GATE
English
Sistemi Elettronici
di Apertura Porte e Cancelli
International registered trademark n. 804888
®
REV 07 - 05/2009
Keep pressed P1 button, LEDP will switch
on.
Keep pressed P1 until the motor M2 starts to
close*.
Release P1.
P1
LEDP
P1
M2
M1
P1
