SEA SYSTEMS
INSTALLATION AND USE
STK1R control panels (Setronik1 Restyling)
STK1R-EN-62-0-A
rev0
24/01/2019
1.05 | 1.06 Car door type
DG0
DG1
DG2
DG3
DG4
DG5
DG6
1 0 5
DG34
=
[1.05.0]
Side 1 car door type
DG56
=
[1.05.1]
Side 2 car door type
DG0
DG1
DG2
DG3
DG4
DG5
DG6
1 0 6
0 0
DG34
=
[1.06.0]
Side 3 car door type
A value of 0 indicates the absence of the car door on the respective side.
Door type table (for manual car doors, or without car doors)
Door type (DG34 e DG56)
Landing doors
Car doors
1
Manual
Manual
2
Manual
Safety photochell / light curtain
Door type table (for automatic car doors)
Door type (DG34 e DG56)
Description
With manual
landing doors
With automatic
landing doors
3
10
Door motor directly driven by contactors, with open/close limit switches
4
11
Door motor directly driven by contactors, with open/close limit switches and forced closing while
car is running
5
12
Electronically controlled door motor, no limit switches monitoring, permanent O/C commands
6
13
Electronically controlled door motor, no limit switches monitoring, timed removed O/C commands
7
14
Electronically controlled door motor, permanent O/C commands, with single limit switches
monitoring input
8
15
Electronically controlled door motor, removed O/C commands, with single limit switches
monitoring input
9
16
Electronically controlled door motor / directly driven by contactors, removed O/C commands, with
two independent limit switches monitoring inputs
20
17
Electronically controlled door motor, permanent O/C commands, with two independent limit
switches monitoring inputs
21
18
Electronically controlled door motor, permanent opening command, forced closing command
while car is running, with two independent limit switches monitoring inputs
22
19
Electronically controlled door motor / directly driven by contactors, removed O/C commands,
forced closing command while car is running, with two independent limit switches monitoring
inputs
23
30
Electronically controlled door motor / directly driven by contactors, removed O/C commands,
forced closing command while car is running, with only the opening limit switch
24
31
Serial controlled car door operator Fermator VF7-CAN “SEA“ (see note 5), permanent O/C
commands
25
32
Serial controlled car door operator Fermator VF7-CAN “SEA” (see note 5), removed O/C
commands, with forced closing command while car is running
26 … 29
33 … 39
Reserved
Notes
1.
“Permanent O/C commands” means that the opening / closing commands are not removed (turned off) when the car door is
fully open / closed.
2.
“Removed O/C commands” means that the opening / closing commands are removed (turned off) when the car door is fully
open / closed.
3.
“with single limit switches monitoring input” means that there is only one door state monitoring signal that change state when
the door is fully open or fully closed
4.
“with two independent limit switches monitoring inputs” means that there are two door state monitoring signals, one that
change state only when the door is fully open, and the other only when it is fully closed.
© 2019
Sea Systems
Page 42 of 99
