Sea Tel ST144-21, Инструкция по установке и эксплуатации, Страница: 34 / 142

Installation ST144-21 C/Ku-Band TVRO
3-12
34. Attach radome lifting brackets
(PN 122848), or other lifting
arrangement, around the
bottom of the upper panel
assembly.
35. Insert a 1” (or longer) bolt
through a fender washer,
down through the bottom
flange of one of the upper
panels and thread it into the
threaded lip of the lifting
bracket as shown in the
picture.
36. Attach three more brackets, in
the same manner, so that the
lifting brackets are in four
equidistant points around the
perimeter of the bottom
flange of the upper panel
assembly.
37. Attach web straps to the four
lifting points.
38. The upper panel assembly is
now ready to lift onto the
lower panels.
39. Set the riser panel assembly
on the base pan.
40. Loosely attach the riser panel
assembly to the base frame
using the hardware provided.
Do NOT tighten the bolts at
this time.
41. Use wedges to lift the riser
panel assembly up off of the
base pan about ½ inch.
42. Install a good bead of
caulking between the bottom
of the riser panels and the
base pan, remove the wedges,
apply loctite to and then
firmly tighten all of the
horizontal flange bolts.