Sea Tel ST144-21, Инструкция по установке и эксплуатации

Страница: 31 / 142

ST144-21 C/Ku-Band TVRO Installation
3-9
12. Repeat caulking, closing and
cleaning the vertical flanges
until all of the lower panel
seams are closed.
13. Remove the tape from the
vertical seams.
14. The lower section of the
radome is now complete.
15. Place short pieces of 2”x4”
boards under the perimeter of
the lower panel assembly to
raise it up off of the ground.
16. Attach radome lifting brackets
(PN 122848), or other lifting
arrangement, around the
bottom of the lower panel
assembly.
17. Insert a 1” (or longer) bolt
through a fender washer,
down through the bottom
flange of one of the lower
panels and thread it into the
threaded lip of the lifting
bracket as shown in the
picture.
18. Attach three more brackets, in
the same manner, so that the
lifting brackets are in four
equidistant points around the
perimeter of the bottom
flange of the lower panel
assembly.
19. Attach web strap lifting sling
to the four points.
20. The lower panel assembly is
now ready to lift onto the
riser panels.
21. Loosely assemble the 8 upper
panels using the hardware
provided. Do NOT tighten the
bolts at this time. Assure
good horizontal alignment of
the panels. Good alignment
of the bottom edge of the
upper panels is important for
good seal between the upper
and lower panels.
NOTE:
The person who is working
inside installing hardware, applying
loctite, tightening hardware and
cleaning the inner flanges will remain
inside until the cap and lifting brackets
are installed.