Sea Tel DTV04, Инструкция по установке и эксплуатации

Страница: 25 / 68

DTV04 HD TVRO Antenna Setup
5-3
6. Use the
LEFT
&
RIGHT
arrow keys to select appropriate digits then use the ‘
UP
&
DOWN’
arrow keys to change value to the “IF Tracking Frequency” recorded above. ___________
□
7. Press the
ENTER
arrow key to submit value to RAM. _____________________________
□
8. Press the ENTER arrow key to move down in receiver selection to BAUD and change value
in same manner as in Step 6 to the “Baud Rate” recorded above. ___________________________
□
9. Press the
ENTER
arrow key to move down in receiver selection to TONE. ____________
□
10. Use the
LEFT
arrow key to select parameter and use the ‘
UP
&
DOWN’
arrow keys to
change tone state on/off value to the “TONE” state recorded above. ________________________
□
11. Press the
ENTER
key to submit to RAM. _______________________________________
□
12. Press the
ENTER
key to move down in receiver selection to Volt. ___________________
□
13. Use the
LEFT
arrow key to select parameter and use the ‘
UP
&
DOWN’
arrow keys to
change value to the “Volt” recorded above. ____________________________________________
□
14. Press
ENTER
key to submit to RAM. __________________________________________
□
15. Press the ENTER arrow key to move down in receiver selection to FEC. ______________
□
16. Use the LEFT arrow key to select parameter and use the ‘ UP & DOWN’ arrow keys to
change Forward Error Correction value to the “FEC” recorded above.________________________
□
17. Press the
ENTER
arrow key to submit to RAM. __________________________________
□
18. Press the ENTER arrow key to move down in receiver selection to NID and use the
‘
UP
&
DOWN’
arrow keys to change NID value to FFFE. __________________________________
□
19. Press the
ENTER
arrow key to isolate ‘SAT’ in the upper left-hand corner of screen. ____
□
20. Use the
LEFT
&
RIGHT
arrow keys to select appropriate digits then use the ‘
UP
&
DOWN’
arrow keys to change value to read 101W. ______________________________________
□
21. Press the
ENTER
key and observe the Targeting LED on the DAC2202 front panel. _____
□
22. When the Targeting LED turns off, press the
TRACK
key. __________________________
□
23. Press the
NEXT
arrow key until ‘SAT’ window is displayed and record THRS (Threshold)
value___________ ________________________________________________________________
□
24. Press the
NEXT
arrow key until Antenna window is displayed. _____________________
□
25. Record targeted AZ and EL position values.
AZ___________EL____________ ____________________________________________________
□