Sea Tel DAC-03, Инструкция по установке и эксплуатации

Страница: 56 / 80

Maintenance & Troubleshooting DAC-03 Tracking Antenna Controller
7-6
If the ACU does not respond to a status request
(Paper Clip button) the module may have been
erased by a previous action. It can still be
programmed but you need to contact the Sea Tel
service department for instructions.
11. Press ‘START’ to put the selected module
into programming mode. After 2 to 3
seconds, you should see an echo of
something like graphic to the right
0050 (Checksum of memory after serial load,
0050 for initial start)
V11 or V31 (Version number of module
bootloader)
12. Press ‘ERASE’ to clear the current Flash
program memory. The screen should
now respond ’
+ ’ for ACU programming.
If it responds with some other characters
or the ‘+’ is not present, check to be sure
that Tracking has been turned off and
press ‘ERASE’ again. Do Not continue
until a proper response is achieved.
13. Press ‘UPLOAD’ to begin sending the new
hex file program update to the ACU
module. A dialog box will appear to allow
you to select the file to be programmed.
14. Program Terminal will send the new file
to the desired module and you will see
an “Upload” dialog box with a “Cancel”
button.