Sea Tel DAC-03, Инструкция по установке и эксплуатации

Страница: 44 / 80

Setup DAC-03 Tracking Antenna Controller
5-8
5.3.19. SAVE NEW PARAMETERS
Press UP arrow and ENTER to save any recent changes into the ACUs NVRAM for permanent
storage. If changes are made and not stored, they will still be effective but will be lost when power
is removed or the RESET key is pressed. Press AUX2 and CLEAR simultaneously to access this
function directly from any other menu display.
5.3.20. REMOTE COMMAND
Use to enter diagnostic commands to the PCU. Allows sending any arbitrary command to the PCU
from the Command window. All checksums and response strings are handled by the DAC-03.
Requires an understanding of the command set for the PCU being addressed. Key in ".nnn ENTER"
where nnn is the ASCII value of the command character to send. The character will appear in the
command window followed by 4 zeros. Key in the numeric command value and ENTER. The
command will be sent to the PCU. PCU response will appear in the lower display. Some of the
remote commands allow you to monitor values which are viewed in the Remote Monitor window.
Refer to the Maintenance & Troubleshooting section of your antenna manual.
5.3.21. REMOTE MONITOR
Use to monitor the results of a diagnostic command which was sent to the PCU. Allows monitoring
any status request from the PCU in the DAC-03 Monitor window. Select the REMOTE COMMAND
window and key in ".nnn ENTER" where nnn is the ASCII value of the desired status request
character. Select the REMOTE MONITOR window and the status request will be updated
approximately 5 times per second.
5.3.22. DISHSCAN
Allows you to view, or change, the DishScan ON/OFF status. Press UP arrow and ENTER to turn
DishScan ON. Press DOWN arrow and ENTER to turn DishScan OFF. If you change this remote
parameter, you must save the change using REMOTE PARAMETERS (see below).
5.3.23. SAT REF
Allows you to view, or change, the Satellite Reference Mode (SAT REF) ON/OFF status. Press UP
arrow and ENTER to turn Satellite Reference Mode ON. Press DOWN arrow and ENTER to turn
Satellite Reference Mode OFF. If you change this remote parameter, you must save the change
using REMOTE PARAMETERS (see below).
5.3.24. REMOTE TILT
Allows easy access to the tilt adjustment commands. Press UP arrow and ENTER to select Tilt
adjustment Test mode. Press 5 to center the tilt sensor adjustment. Press 4 or 6 to adjust the tilt
left or right. Press 2 or 8 to adjust the tilt forward or backward. Press DOWN arrow and ENTER to
restore normal system operation.
5.3.25. REMOTE PARAMETERS
Allows any remote parameters that have been changed (via Remote Command or Remote Tilt) to
be saved. Press UP arrow and then ENTER to save the parameters in the remote PCUs NVRAM. Any
REMOTE changes must be saved to NVRAM in the PCU, or they will be lost when power to the
antenna is cycled or remote reset command is issued.