Sea Tel COASTAL 18, Инструкция по установке и эксплуатации

Страница: 23 / 78

Coastal 18 Ku-Band TVRO Installation
4-1
Figure 4-1 Possible Antenna Radome Assembly mounting
locations
4. Installation
Installation of your Coastal Series Antenna system must be accomplished by or under the supervision of
an authorized Sea Tel dealer for the Sea Tel Limited Warranty to be valid and in force.
Good planning of
the installation will provide the best results. Below is some guidance on issues that are important to consider
when planning the installation.
Planning is the key to a good installation. Read the installation information below thoroughly before beginning the
actual installation. Then review your plan to adjust for any details that may have been overlooked.
A full scale Installation Template (drawing 118092) has been provided to locate the cutout areas and mounting
holes for the antenna radome and for the antenna control panel. The radome template section of the drawing
includes the outer perimeter of the radome base so you can insure that the radome will fit in the area chosen.
4.1. Site Selection and Cable Routing
Determine the optimum mounting location for the antenna radome assembly. It should be installed where:
1
The antenna has a clear line-of-sight view to as much of the sky as is practical. Choose a location
where masts or other structures do not block the satellite signal from the dish as the boat turns.
2
The antenna is at least 5 feet away from other transmitting antennas (HF, VHF and radar) that may
generate signals that may interfere with the Coastal Series antenna. The further away the Coastal
antenna is from these other antennas, the less impact their operation will have on it.
3
The antenna radome assembly should be rigidly mounted to the boat. If necessary, reinforce the
mounting area to assure that it does not flex due to the boat motion or vibration.
Choosing the best mounting location on
smaller boats, where there are fewer
possible locations to choose from, is
frequently a compromise. Figure 4.1 is
provided to make some location
comparisons. The “poor” location is poor
because over half of the antenna’s
viewable sky is blocked by the overhang
above it. The “better” location has less
blockage, but the upper deck and the mast
will cause some blockage when the
antenna is at lower elevations. The “best”
location has no blockage from raised
platforms, mast or the body of the radar.
Antenna Control Panel - The antenna
control panel should be mounted in a
convenient location for the operation of the
antenna system. It should be near one of
the satellite receiver/television locations so
that the receivers’ TV screen can be
viewed while the antenna is being
operated. The antenna control cable is
routed from the radome to the control panel, so routing path and cable length are also important
considerations in choosing the location of the control panel.
Satellite receiver(s) and television set(s) - Satellite receiver(s) and television set(s) should be mounted near
each other in convenient viewing locations. If enclosed in a cabinet or panel, assure that there is adequate