6
Instructions on how to attach the oars to the rowing arm is
explained in the instructions for the Sliding Seat.
B) Sliding Seat Configuration
Place the sliding seat on the preassembled frame. Then secure
the sliding seat to the preassembled frame with 4 large black
knurled nuts (a) and 4 large washers (b) as shown below.
Attach the sliding seat cushion to the the sliding board for
comfort during rowing.
Place the assembled Sliding Seat on your PaddleSki between
the middle and the aft yoke. The rowing arm should lie towards
the stern. The assembled sliding seat must touch the middle
yoke as shown to prevent movement of the frame while rowing.
Loop the included foot strap around the bolts of the aft yoke to
lock your feet while rowing.
Now snap the collapsible oars together, attach the oarlock pins
with bolts and wing nuts. Now drop the oarlock pins in the
fittings on the two end of the rowing arm as shown.
PaddleSki Side Motormount
for Electric Motor
The motormount for the Sea Eagle PaddleSki contains the
following parts shown above:
1 Motormount Yoke Board, 1 Motormount upright board, 4 Bolts
2 L Brackets and 2 Straps.
Remove the rear yoke from
your PaddleSki.
Place the Motormount Yoke
Board over the yoke bolts
and secure with the yoke
nuts. The holes on the
outboard side should be
toward the rear so the
motormount upright board
can be attached.
Most people prefer to operate the motor with their left hand.
You can also attach the motormount board with the motor on
the right side of the PaddleSki if you would rather steer with
your right hand. Just make sure that the two holes on the
outboard side are closer to the rear than the front.
Attach the L-Brackets to the
motormount yoke board and
motormount upright board as
shown. The motormount
upright board should be flush
with the rear of the
motormount.
Use one of the enclosed
straps to secure the
motormount yoke board. Run
the strap through the small
D-rings fore and aft of the
board and tighten. Secure
your battery with the other
strap as shown at left.