3
To close, tightly pinch the pipe
section of the valve with your
forefinger and thumb while you
remove the pump nozzle from the
valve. Squeeze tightly, and hold
the valve at the very bottom so
little air seeps out while you plug
the valve.
Once the valve is plugged in, it
can be pushed down into the base
and out of the way. Getting this
right might take a few attempts,
but it becomes second nature
quickly.
To deflate, simply pull out the plug and air will rush out.
Deluxe One-Way Valves: For New
Deluxe Kayak Seats and Deluxe Fly
Fishing Seats.
This is a 3 piece
screw type valve comprising of
valve seat, the middle section for
inflating, and the outer valve cap.
Insert the
largest nozzle
included with
your foot pump
into the middle
section of the valve to inflate
these seats. Make sure that the
middle section of the valve is
tightly screwed on to the valve seat before you start inflating
the seats. Put the outer cap on after you finish inflation. To
deflate, unscrew the middle section of the valve and the air will
rush out. You do not need a pump for deflation.
Pumps
A41 Foot Pump
: This pump is used
for all our products and is one of
the best on the market today. We
firmly recommend you always carry
your A-41 on board for safety.
Attach the hose to the valve on
the right side of the A41 foot
pump as shown in the pictures to
inflate. Use the One Way Valve
adapter included with your
transom boat to inflate this valve. Insert the valve adapter into
the hose of the Foot Pump. Push the adapter into the valve and
turn clockwise to lock it in position. With the foot pump,
inflate each chamber till you cannot pump any more air into it.
At this stage the foot pump will
become extremely hard and you
will not be able to press it any
further. That means the chamber
has reached its optimum pressure.
Withdraw the adapter from the
valve and close the valve cap.
Electric Pumps
MB-100 High Pressure Electric Pump
is specifically designed for high
pressure inflatable boats like our
transom boats. It has a set of
alligator clips to hook on to a 12
Volt car battery just like a jump
cable.
Make sure your pump is off and hook the red positive alligator
clip to the positive terminal of your battery. Hook the negative
clip to the negative terminal of your battery.
Adjust the pressure dial on the MB-
100 pump to 220 milibar, or 3.2
PSI as shown, and plug the hose
into the valve opening above the
dial for inflation. The other opening
on the other side of the pump is for
deflation, which is not required for
our boats.
Please note, the MB-100 Pump
comes with a cluster of 8 adapters
that are numbered from 1 to 8.
These numbers are written on the
arms of the cluster that hold each
adapter. You have to carefully read
these numbers on the arms of the
cluster.
Attach the hose to the MB100 and
the other end of the hose to the
threaded side of adapter # 7 from the cluster. Detach this
adapter from the cluster and insert the other side of it into the
threaded side of adapter # 1. Now push the adapter # 1 in the
Recessed One-Way Valve and switch on the pump. It will change
gears during inflation and automatically stop once the pontoon
is fully inflated to 3.2 psi air pressure. When you inflte the
pontoon make sure that the valve stem of the Recessed One-
Way Valve is in the up position. The divider on adapter #1 will
push the pin down to let the air in for inflation.
BST Super Turbo Electric Pump
The BST features a two
stage pumping system - a
high speed fan to quickly
inflate your hull, and a
piston pump to achieve the
desired pressure our
transom boats need. Not
1
2
3
4
5
6
7
8