8
FastTrack |
ASSEMBLY & INFLATION
Inflate sides
to 3.2 psi. PSI is marked
in red.
Note: Pressure gauge will
not begin to register until
boat begins to get
pressurized.
Inflate Floor:
Tuck edge of floor under
the sides. Inflate floor to
3.2 psi.
Note: floor and keel can
be inflated to 10 psi but
will not improve
performance or make
boat significantly more
rigid.
When inflated, the floor
should make a “chine”
below the sides. If floor
needs to be pushed down,
turn boat on its side, push
downward on the side
and hit the floor with a
fist.
Floor Drains
Screw the floor drain
caps down tightly. Drains
should be closed during
use except in whitewater
situations. Boat will
partially fill with water
with drains open.
Floor drains are intended
to drain accumulated water
while ashore. When open,
tuck caps under the floor
so they do not block the
openings. If drains leak,
refer to Troubleshooting.
Inflate keel
Valve is located under the
sprayskirt. Keel takes one
pump stroke with the
Bravo 4.
Fishing Rig (OPTIONAL)
To assemble and install the
Swivel Seat Fishing Rig,
please refer to the
supplemental
instructions at the end of
this manual.
Kayak Motor Mount
(Optional)
Kayak Motor Mount for
small trolling motors
includes an aluminum
board, L-brackets, 4’ straps,
mounting block and
hardware.