Trouble Shooting
5. While holding the
Propeller, use an M6
socket wrench to
remove the nut from
the Propeller shaft as
shown in fig.16.
6. Slide the Propeller off the shaft, taking care not to lose the
drive pin or washers.
7. Remove the blockage from the Propeller or Propeller Shaft.
8. Replace the drive pin (if removed), see fig.17, and
Propeller. Turn the Propeller slowly until you locate the pin
and push the Propeller fully on.
20
Fig.15
x 12
Fig.16
Beware of
sharp corners
when servicing
Unit does not function
If the Propeller does not start when the trigger(s) is/are
pressed, make sure:
1. The Master Switch is ON (see fig.3)
2. The Battery Pod is fully charged. (see page 15, charging
the Battery Pod)
3. The battery compartment is dry.
Blocked Propeller
If the Propeller becomes blocked, it will be necessary to
open the Protective Grilles to remove the obstacle.
UNDER NORMAL USE the grilles must not be opened.
NEVER turn ON the propeller when it is blocked, it will
cause serious damage to the gear box.
Opening the grilles to remove obstruction
1. Take the SEASCOOTER™ EXPLORER out from the
water.
2. Make sure the Master Switch is in the OFF position.
3. Disconnect and remove the Battery Pod - see page 15,
step 1 - 5.
4. Unscrew the twelve Grille screws as shown in fig.15 to
remove the Inner Nozzle and Propeller Nozzle.
Fig.17
Drive Pin In Position
19
