Charging the Battery Pod
To charge the Battery Pod follow these instructions.
1. Always ensure that the Master Switch is in OFF position.
(see fig.5)
2. Always ensure that the SEA-DOO
®
SEASCOOTER™
EXPLORER is out of the water, dry and placed in a dry area.
3. Pull the four Latches down and remove the Nose Cone by
using the left and right Latches to break the seal if
necessary. (see fig. 11)
7. Plug the Charging Base into the mains, and turn on
the supply.
8. Charging will take around 12-14 hours for a fully
discharged battery. When the Battery Pod is charging,
the RED LED light on the Battery Pod remains
flashing. When the battery is fully charged, the GREEN
LED flashes. (see Fig.12)
9. Unplug the Charging Base
from the mains.
10. Allow battery to stand for
30 minutes before using it.
11. Unplug the Battery Pod
from the Charging Base.
12. When ready to use,
reconnect to the unit in the
correct position. (see fig.13)
13.
Make sure the O-ring
Seals and sealing surfaces
are clean and lubricated
before replacing the Nose
Cone. (see fig.14)
14. Replace the Nose Cone and close the Latches.
4. Allow two minutes for any gases to dissipate.
5. Take out the Battery Pod from the unit.
6. Connect the Battery Pod to the Charging Base. (see fig.12)
16
15
Press
inward
to open
Inner
Latches up
Fig.11
Left and
right Latches
Top and Bottom
(on Back) Latches
Fig.12
Charging Base
Battery Pod
Charging
Indicator
Fig.14
O-ring Seals
Battery Pod
Sealing Surface
Fig.13
