The device won't turn on when the button is pressed
Make sure the power cables are connected and the wire colors match. If not, correct the
error and try switching the device on again. Disconnect and reconnect the cables even if
the wire colors match.
Make sure the battery is inserted correctly into the battery holder and that the battery's
positive (+) side is facing up. Make sure the two positive (+) contacts on the battery holder
are above the battery and pressing against the battery’s outer edge. See the illustrations in
Chapter 7 on “Inserting and replacing the battery”.
If the battery is not inserted correctly, remove the battery using the procedures in Chapter
7 and correctly reinsert the battery. After reinserting the battery, try to switch the device
on again.
If the battery is inserted in the holder correctly and the Leak Sentinel’s LED is not blinking,
try using a fresh battery.
If the problem persists, contact your seller for service.
The LED indicator is solid red or flashes alternately red/green upon startup
Try to reset the circuit pressing and holding the button for more than 3 seconds. The
device should flash green briefly, then keep on flashing red steadily. See Chapter 6 on
»RESET function«.
Disconnect and reconnect the power cables or remove and reinsert the battery to reset
the circuit. If the reset was successful, the device should flash green briefly, then keep on
flashing red steadily. See Chapter 6. on ” RESET function”.
If the problem persists, contact your seller for service.
