3.
The “Where It’s At” LED Light:
All ME Jr. Splitter Boxes are equipped with a “Where It’s At” light jack, for this optional
accessory. When an alarm occurs, the light will )))flash((( to alert associates of
the location of the alarm. Plug them in wherever needed, and adhere the light
where it can be seen from a distance, (usually at the top of a display).
Sensor Connections: –
To Splitters
1.
Insert a sensor’s modular plug into a splitter
or strip port. Repeat this procedure until all sen-
sors have been plugged in.
Sensor Connections: – To Product (SK-800
Series Sensors)
2.
Choose a small flat area on the back of the
product where the sensor is to be applied.
VERY IMPORTANT!
NOTE: Clean the area on the
product and the sensor with
Alcohol Prep Pads. Wipe these
surfaces DRY with a clean paper
towel. If the paper towel shows
dirt, REPEAT THIS CLEANING STEP until the
surfaces are CLEAN & DRY!
3.
Remove an SK-905 (1" x 2") Rectangular
Adhesive Pad from its backing sheet. Apply the
adhesive pad to the bottom of the
sensor, making sure that the center
hole of the adhesive lines up with
the plunger on the bottom of the
sensor. (See Fig. 6 below).
4.
Remove the backing sheet from the other
side of the adhesive pad and position the
Rectangular Sensor over the flat area of the
product previously cleaned. Press the sensor
firmly into place to insure a proper bond, (as
shown in Fig. 7 above). The light on the sensor
will light RED when the sensor is applied correct-
ly to the product
Clean &
Wipe Dry
Rectangular
Adhesive Pad
SK-905
Fig. 6
Fig. 7
Remove
Adhesive
Backing
Sensor Connections:– Lenses
(SK-843 Series Lens Sensor)
5.
Insert the Tie-Wrap into the Lens Sensor as
shown in Fig. 8, and wrap it around the lens. Pull
the Tie-Wrap tight, and cut off the excess with
wire cutters or scissors.
Sensor Connections:– Cameras
w/Removable Lenses
(SKD-0443 Series Dual Sensor)
6.
The Dual Sensor, (shown in Fig. 9)
is a combination of the Rectangular Sensor and
the Lens Sensor for cameras with removable
lenses. Follow Steps 1 thru 5 for installation pro-
cedures.
SK-943T
Tie-Wrap
SK-943T Tie-Wrap
SKD-80443PC/LE
Dual Sensor
SK-843PC/LE
Tie Sensor
Fig. 8
Fig. 9
Sensor Connections:
–
(SK-853 Series Collar Lasso Sensor)
7. The Collar Lasso Sensor has a wire
connector that loops around the product and
plugs back into itself using a telephone mod-
ular plug.
8. The Collar “Lasso”
can be installed onto
products by “Lassoing”
any enclosed part of the
product and plugging this module back into
itself, (see Fig. 10).
SK-853
Collar Lasso Sensor
Fig. 10
