AC Power Light
Will be lit when the SK-195 AC/DC
Power Supply is supplying power to
the Alarm Center.
Low Battery Light
Will )))flash((( when batteries
should be replaced.
Will )))flash((( if no batteries are
installed and the AC power is on.
Key Disarm Light
Will be lit when the Alarm Center is
Disarmed using the Key-Lock.
Infrared Disarm Light
Will be lit when the Alarm Center is
Disarmed using the Infrared remote.
Circuit “A” Light &
Circuit “B” Light
Will be lit if a Termination
“Shunt Plug” is not installed.
Will )))flash((( if an alarm has
been caused on that circuit.
Will not be lit when all
sensors and the Termination
“Shunt Plug” have been
properly installed.
Point the Infrared
Transmittter at
the Receiver within
a 2 foot range.
Infrared Transmitter
2.
)
)
)
SK-HORN
Remote Horn
SK-800ME
I
ME Jr. plus 2 Alarm Module
SK-808ME
8 Port ME Splitter Box
SK-195
AC/DC Power Supply
Installation:
The ME Jr. plus 2 Control Module has (2) circuits; one marked Circuit “A” and one marked
Circuit “B”. Any combination of up to (10) splitters can be Daisy-Chained to the Control
Module as long as the total number of splitters from both circuits does not exceed 10. If all
10 splitters are chained to a single circuit, a “Shunt Plug” must be installed in the other
circuit. A “Shunt Plug” must also be installed in the last splitter of each chain.
Special Note: Place the ME Jr. plus 2 in the Key Disarm Mode to install splitters and sen-
sors. The Key Disarm Mode prevents the unit from Automatically Arming after (4) minutes.
•
After arranging display, connect (SK-808ME) Splitters together using the 6 ft.
SK-847 cables (provided with each splitter).
If specific lenth cables is required: you may order them using Part No.
(SK-847-x), where x = the length of the cable in feet.
•.
Connect an ME Jr. Sensor to a port on the Splitter and to the corresponding display product.
Selecting Sensors for Display Product: (Sensors are available in Straight (P/LE) & Coiled (PC/LE).
SK-109
Telephone Modular “Shunt Plug”
SK-847-x
(x = Cable Length in Feet)
Extension (Connects Alarm Module
to Splitters & Splitters to Splitters)
SK-802
1" x 1" Bug Sensor
SK-843
Tie Sensor
SK-861
Ant Sensor
Other Straight,
Coiled &
Dual Sensors
Are
Available.
Ask Your
Customer Service
Representative
For Details.
SK-804
1" x 2" Rectangular
Sensor
SK-827
Parallel Port Sensor
SK-853
collar Lasso Sensor
SK-855
Slim-Line Sensor
SK-863
Mini Phone Sensor
SK-890
Bendable Label
Sensor
