4641 East Ivy Street, Mesa, AZ 85205 | (480) 256-0017 | [email protected] | SCYNCE.AG
7
the science of yield
• THIS PRODUCT MUST BE INSTALLED IN
ACCORDANCE WITH THE APPLICABLE
INSTALLATION CODE BY A PERSON FAMILIAR
WITH THE CONSTRUCTION AND OPERATION OF
THE PRODUCT AND THE HAZARDS INVOLVED
ATTENTION
INSTALLING THE FIXTURE
INSTALLATION PREP
MOUNTING THE LIGHT FIXTURE
ELECTRICAL CONNECTION
CONTROLING THE LIGHT
1.
Switch off main voltage
2. Refer to your light plan. Arrange boxed light
fixtures in specified mounting locations.
3. Remove the fixture from the packaging and
check contents.
4. Gather any additional tools and/or hardware that
may be required to mount the fixture.
The Dragon XL 1200/LX 600 is designed to hung using the mounting brackets at either end
of the fixture’s cowling. There are four mounting hole options, each of which will aim the
fixture at a different angle. The optional aiming angles are; 0° 15°, 30°, and 45°.
See Figure 1 for additional details.
When mounting the Dragon XL1200 or XL600 fixtures in an array a minimum distance of 8
inches side to side and a minimum distance of 1 inch end to end must be maintained. When
mounting next to a ceiling or wall, movable partitions, and the like, insure a minimum distance
of 1.5 inches is between the fixture and the ceiling and 8 inches between the fixture and the
wall and other adjacent objects.
Dragon XL 1200/XL 600 is equipped with a 7ft power cord,
terminated with a standard wall pug (NEMA 5-15).
Simply plug the light in and you are ready to go.
Always ensure that fixtures are compliant with local building codes.
When routing the fixture power cord ensure that;
- The cord is not concealed or extended through a wall, floor,
ceiling, or other parts of the building structure.
- The cord is not located above a suspended ceiling or
dropped ceiling.
- The cord is not permanently affixed to the building structure.
- The cord is routed so that it is not subject to strain and is
protected from physical damage.
- The cord is visible over its entire length.
Dragon XL 1200/XL 600 is equipped with four
independent channels of LEDs (White 2700K, White
4200K, White 6000K, and Red 600 nm). Each
channel can be independently dimmed from 0% to 100%.
Channel dimming can be adjusted on-demand using the
mobile app (See Mobile App Instructions for details) or
by setting up an embedded schedule in the light (See
Scheduling Instructions for details).
Figure 1: Fixture
mounting detail
To ensure safe operation of the lighting equipment it is
necessary to control the temperature of the room by
mechanical ventilation or cooling system to below the
maximum ambient operating temperature of 40ºC (104ºF).
SINGLE
PHASE CORD
TERMINATION
DOUBLE
PHASE CORD
TERMINATION
BLACK
Line
WHITE
Neutral
GREEN
Ground
BLACK
Line
WHITE
Line
GREEN
Ground
