Sculpt Multivision 800, Инструкция по установке и эксплуатации

Страница: 31 / 48

31
5.
inBUilt into iSlanD Wall
step 7: lift up door assembly
(if not reQuired go to step 9)
**iMPortant**
refer to images page 38. liFt uP Door assEMBly.
three bolts mount the lift up door mechanism. it is
recommended that you use two solid pieces of timber
approximately 450mm long in order to assist in the assembly
of the door.
1. lift the door into position and place door lift mechanism in
position above fireplace door.
2. lift ballast and place timbers in-between guillotine
movement of slider to prevent ballast from coming back
down.
3. fix the 3 silver bolts into the heater frame through the
ballast frame
4. release weight from the wood when mechanism is secure
in place.
5. lift ballast and secure chains through sprocket onto the
small bolts attached to door (make sure spacers for chain
are inserted into link attached to door)
6. release weight from the wood when chain is secured on
both sides of door.
Door should now lift and lower with ease, please test this
before continuing.
step 9: layla 3 trim with lift door
(if not reQuired go to
step 11)
**IMPORTANT**Trim must be fitted onto the firebox PRIOR to
installing the front of the masonry enclosure.
1. Put the trim on the front of the firebox
2. On the side of the façade of the firebox drill two holes at
4.2mm
3. the holes must match with the slotted holes on the trim
4. put the trim into place
5. fix the trim with the screws provided (screws m5 +
washers)
layla 3 trim with no lift door
(if not reQuired go to step 11)
If the trim is to be assembled to fit onto a firebox not equipped
with a lift up door, you will need to weld the bracket (width
5 mm each). the brackets (2x5 mm) are necessary to
compensate the initial width of the trim.
step 8: outdoor air kit
(if not reQuired go to step 10)
any depression or lack of fresh air within the room where the
fireplace is located can cause emanation of smoke to flow
back into the room and the unit to run inefficiently. It is highly
recommended that an outdoor air Kit be installed in six or more
star rated homes, or any install where a mechanical device (ie.
fan), takes air from the fireplace cavity & transfers it.
place adaptor on the back of the unit and screw into position.
attach the flexi flue to the adaptor which can either run under
floor if the home is on stumps and connect to a metal vermin
proof cowl or a custom kit can be made with solid flue lengths
going from the enclosure of the fireplace and into the roof
cavity.