Sculpt Multivision 800, Инструкция по установке и эксплуатации

Страница: 18 / 48

18
step 8: first length of flue
Place the first single skin length of flue (with no crimp ends)
around the outside of the spigot. you may also use a heat
resistance sealant(i.e.firecork) to seal any air gaps. Before
installing the remaining lengths of flue please continue to the
next step.
step 9: side walls & Ventilation
**important**
Ventilation is required on the enclosure to assist with air
circulation. a minimum of two air intake grills are required
at the bottom and a minimum of two air out-take grills are
required on top of the masonry enclosure (2X inflow 2X
outflow). all vents can be positioned either side or the front of
the masonry enclosure. all vents must adhere to the minimum
vent size of size 300mm2.
Using masonry(ie. clay bricks) build a layer of bricks from
the base to the top of the ceiling on either side of the firebox.
remember to leave a minimum 25mm air gap on all edges.
*the vent sizes and quantity can be adapted and changed
but they must meet the minimum ventilation requirements
as specified above. For custom made vents please contact
your nearest dealer. all Vents must not be plastiC or
Combustible.
step 7: layla 3 trim with lift door
(if not reQuired go to
step 8)
**important**
Trim must be fitted onto the firebox PRIOR to installing the
front of the masonry enclosure.
1. Put the trim on the front of the firebox
2. On the side of the façade of the firebox drill two holes at
4.2mm
3. the holes must match with the slotted holes on the trim
4. put the trim into place
5. fix the trim with the screws provided (screws m5 +
washers)
layla 3 trim with no lift door
(if not reQuired go to step 8)
If the trim is to be assembled to fit onto a firebox not equipped
with a lift up door, you will need to weld the bracket (width
5 mm each). the brackets (2x5 mm) are necessary to
compensate the initial width of the trim.
4.1
maSonry BricK inStallation
*all air vents must have a minimum clearance to combustibles
of 600mm in front and 300mm above the metal vent itself.