TB-9079
Page 5 of 17
© 2017 DESCO INDUSTRIES, INC.
Employee Owned
SCS
- 926 JR Industrial Drive, Sanford, NC 27332
East: (919) 718-0000 | West: (909) 627-9634 • Website:
StaticControl.com
12. Connect the power adapter to the power jack
located on the right-side of the WS Aware Monitor.
Route the wire from the supply to a nearby AC
outlet and plug it into the outlet. Make sure the
voltage and frequency match those listed on the
power supply. The WS Aware Monitor is now
powered.
Figure 5. Wiring the WS Aware Monitor to two
workstations
Push & Clinch Snap
Mat Monitor Cord
Operator Remote
Operator Remote
Cable
WS Aware Monitor
Left-Side
Grounded Worksurface Mat
Figure 6. Wiring the WS Aware Monitor to two metal
tools
Tool Monitor Wire
(not included)
Operator Remote
Operator Remote
Cable
WS Aware Monitor
Left-Side
Grounded Metal Tool
NOTE: Worksurface must have a conductive layer such
as Dual Layer Rubber or Dissipative 3-Layer Vinyl with
conductive buried layers. SCS workstation monitors are
not recommended for use with homogeneous matting.
Relay Terminal
The WS Aware Monitor features a normally closed
optical relay terminal that can be integrated with
electronic tools, lights, buzzers, etc. The relay opens
when the monitor enters an alarm condition, and it
remains closed otherwise. Use the Molex #51021-0300
male connector to pair wiring with the female connector
on the WS Aware Monitor.
Parameter
Rating
Peak Blocking Voltage
30 V
P
Load Current
140 mA
rms
/ mA
DC
On-Resistance (max)
22 ohms
Figure 7. Connecting the WS Aware Monitor to ground,
Ethernet and power.
WS Aware Monitor
Right-Side
Power Adapter
Ethernet Network
Cable
Monitor Ground
Cord