10
BRUSH INSTALLATION OF GBZ-430BT/530BT
1.
Lift the brush base by acting on the pedal.
2.
Keeping the brush base lifted, put the brush under the base.
3.
Lower the base by release the pedal.
4.
Press the operator present control lever 6 and the brush will be hooked automatically.
5.
Rotate the knob which indicates as following right picture, you can gain different advance speed.
WORK
PREPARATION
1.
Connect the connector
①
to the batteries and push the power butto
n②
.
2.
Press the brush motor switch
③
and lever 6 to start the brush motor.
3.
Press the vacuum motor butto
n④
to start the vacuum motor.
4.
Turn the speed control switch 14 in clockwise.
5.
Push the moving switch 15 and lever 7 to start the driving motor.
6.
Act on the valve lever
⑤
to adjust the detergent solution quantity: it should be enough to wet the floor but not as much
as flow out the splash guard. The detergent quantity depends on floor type, on cleanliness and on speed.
7.
Lower the squeegee by acting on the squeegee lever
⑥
.
8.
During the first few meters check if the water is sufficient and the squeegee dries the floor perfectly.
