Scout X10, Руководство по обслуживанию

Страница: 22 / 80

22 Service manual - X10
Troubleshooting
Problem Cause Solution
Motors make excessive
noise Worn carbon brushes Check carbon brushes and
collector. If needed replace
brushes or motor.
Wheelchair wobbles overall
or moves up and down
when driving Drive wheels have radial
misaligned . Can be
caused by long (weeks)
inactive periods Check for misalignment of
tires. If misaligned, reduce
tyre pressure to 1 bar, drive
for several minutes at
moderate speed and
increase pressure again to
advised value.
Misalignment can be
reduced this way. If not
sufficient replace wheel.
Seating actuator does not
function Current setting is not
correct Check programming and
make corrections if needed.
Contact manufacturer for
correct settings.
Cables not connected or
cables damaged Check cables and replace if
needed.
Wheelchair goes into fault
status when actuator is
operated Actuator has a short circuit
that becomes active when
the actuator is operated.
Replace actuator.
Actuator inhibit is active Check program to see what
actuator inhibit is present.
Check if inhibit signal is
functioning correctly.
(example : with lift and tilt
to maximum, recline will no
longer move backwards.
Actuator module (output)
fault Try actuators on different
output channel to check
what output channel has a
fault.
Seating actuator only
functions for a short time Maximum current setting is
too low Check programming and
make corrections if needed.
Contact manufacturer for
correct settings.
Actuator time out setting is
too short (or actuator speed
is too low) Check programming and
make corrections if needed.
Contact manufacturer for
correct settings.
Actuator is internally not
functioning properly Check actuator
temperature after operation
and/or check for excessive
noise when operated.
Replace actuator.